C-USP2

Catalog numbers:

    • D-150 mechanical joint ends with accessories and duck tipped rubber gaskets†
    • D-150 mechanical joint ends with accessories and plain tipped rubber gaskets†
    • D-150 mechanical joint ends with accessories and duck tipped rubber gaskets† and bonding set screws in gland
    • D-150 mechanical joint ends with accessories and plain tipped rubber gaskets† and bonding set screws in gland

Specifications:

  • Sizes-- 4", 6", 8"
  • Meets or exceeds all applicable requirements of ANSI/AWWA C509 Standard and is certified to ANSI/NSF 61 & 372
  • Iron body with nominal 10 mils MUELLER® Pro-Gard™ Fusion Bonded Epoxy Coated interior and exterior surfaces
  • Epoxy coating meets or exceeds all applicable requirements of ANSI/AWWA C550 Standard
  • Iron wedge, symmetrical & fully encapsulated with molded rubber; no exposed iron
  • Non-rising stem (NRS)
  • Triple O-ring seal stuffing box (2 above the thrust collar and 1 below)
  • 2" square wrench nut (optional handwheel available)--open left or open right
  • 4" - 8" sizes--250 psig (1725 kPa/17 barg) maximum working pressure, 500 psig (3450 kPa/35 barg) static test pressure
  • Designed for potable water applications.
† See page 12.26 for extra gaskets and classes of pipe that cut-in valve will fit.

Options:

  • Position indicators
  • Stainless steel stem: type 304 and type 316
  • Low zinc, silicon bronze ASTM B98-C66100/H02 stem
  • Handwheel
  • EPDM disc and O-rings

Submittal Drawing          Full Line Catalog